Sonifex Software
DHY-03 Firmware Versions
DHY-03 V1.64
- Alterations
- Added Avaya Media Gateway Country Code [111] for Al Jazeera TV.
DHY-03 V1.61
- Alterations
- Line Reversal Min set to 35ms & ring timeout increased from 3->7 secs.
DHY-03 V1.59
- Alterations
- Changed Line Reversal - Now detects single reversal present for disconnect min parameter duration (ms).
DHY-03 V1.57
- Alterations
- Optional AGC on Receive Gain.
DHY-03 V1.55
- Alterations
- Country code fixes from V1.54
DHY-03 V1.54
- Alterations
- New Japan2 country-code with custom remote and impedance settings.
DHY-03 V1.45
- Alterations
- Added divert relay function to DHY-03 standard code (already present in EC)
- Added ability to switch off divert relay function - parameter 2 bit 7 (i.e. add 0x80 to current set value) enables relay - this is default operation
- Added debug info if boot fails - lower led alternates between first and last LED and top row of LEDs are lit with code value (for EC just red Tx/Rx LEDs alternate no code is shown)
- 1 - Uart initialisation failed
- 2 - Codec initialisation failed
- 3 - Silabs chipset initialisation failed
- 4 - Silabs front end chip fails to respond (Si3056)
- 5 - Silabs line side chip fails to respond (Si3018)
- added delay after divert relay release to ensure call is maintained if DHY-03 drops the call
DHY-03EC V1.45
- Alterations
- RX and TX LED's had been swapped in a prior change restored to correct values
DHY-03 V1.43
- Alterations
- RX and TX LED's had been swapped in a prior change restored to correct values
DHY-03 V1.43
- Alterations
- Altered New Zealand Disconnect cadences
DHY-03 V1.41
- Alterations
- Add rev of Silabs chipset version no.
DHY-03 V1.40
- Alterations
- New CC parameters:Display_Type, Adaption_Differential, Adaption_Response
DHY-03 V1.32
- Alterations
- CC's for AVAYA have new settings
DHY-03 V1.31
- Alterations
- Japan disconnect set to Line Reverse
- Fix LINE_OUTPUT double precision mult io_mac
DHY-03 V1.30
- Alterations
- Changed limiter calculation of signal received from line
DHY-03 V1.29
- Alterations
- Added Line In to Tele Out Jumper Mode
DHY-03 V1.28
- Alterations
- JP2 Jumper Function non-operative - fixed
DHY-03 V1.27
- Alterations
- Distortion on telephone limiter when noise gate disabled
DHY-03 V1.21
- Alterations
- Added Avaya disconnect type 375/375ms 400Hz
- Disconnect tone levels multiplied by 4 for finer control (requires any User Tones previously defined to have the treshold level set 4 times higher)
- Bug Fixes
- Wrong User Disconnect Tones were previous set by SCi
DHY-03 V1.19
- Alterations
- New settable line_overload param (P27 for current set and P52,77,102,127,152, 177 for Telephone Interface user sets)
- New DT_PERMANENT disconnect type for permanent line hold
- Added Country Code 118 for Broadcast Bionics/Avaya with permanent line hold
DHY-03 V1.14
- Alterations
- Added BB/Avaya as country code 119
- Added Avaya disconnect tone - 400Hz 375msec On/Off cadence
- Default disconnect time extended to 500msecs
- Bug Fixes
- Cadence disconnect bug fixed
DHY-03 V1.11
- Initial Release
